Fujitsu SPARC Enterprise M4000 User Manual page 66

17. Configure the domain settings.
• Display domain information and specify
the domain configuration. (DCL
displaying and settings (Note 1),
configuration policy settings (Note 2),
System board settings)
• Add or delete a system board.
Note – (1) The Domain Component List (DCL) is definition data for the hardware
resources that constitute a domain. There is one DCL per the logical system board.
Each domain has up to 16 logical system boards. The DCL is used to add a hardware
resource that constitutes a domain and to display resource configuration
information. For details on the DCL, see
page
Note – (2) In the configuration policy settings, a degradation range applicable to
errors detected during initial hardware diagnosis can be specified.
18. Configure the domain mode settings.
• Display and make the domain mode
settings. (Break signal sending on/off,
enable/disable Host watchdog
monitoring, automatic boot setting, CPU
operational mode)
Note – The automatic boot setting enables you to specify whether to boot the Solaris
OS, and sets the auto-boot? OpenBoot PROM variable to be either true or false.
19. Configure the Locale settings.
• Display and set the Locale.
2-10 SPARC Enterprise Mx000 Servers XSCF User's Guide • April 2008
2-87, the Administration Guide, and the Dynamic Reconfiguration User's Guide.
showboards(8), showdcl(8), setdcl(8)
addboard(8), deleteboard(8)
(See Section 2.2.11, "Domain Configuration"
on page 2-87)
Section 2.2.11, "Domain Configuration" on
showdomainmode(8), setdomainmode(8)
(See Section 2.2.13, "Domain Mode
Configuration" on page
showlocale(8), setlocale(8)
(See Section 2.2.14, "Locale Administration"
on page 2-126)
2-116)