Altitude Administration; Table 2-30 Altitude Administration - Fujitsu SPARC Enterprise M4000 User Manual

2.2.15

Altitude Administration

This section explains the altitude settings. The server changes the system monitoring
due to the altitude of the server. Therefore, the operator must set the altitude during
the initial system setting. This setting is done by FEs.
TABLE 2-30
Altitude Administration
TABLE 2-30
Item Description
Display settings Display the altitude settings for the server.
Altitude Specify the location altitude of the server:
A set unit is specified in increments of 100 meters.
The setting of less than 100 meters is rounded up.
Setting Altitude
■
1. Use the showaltitude (8) command to check the current altitude settings.
XSCF> showaltitude
1000m
2. Use the setaltitude (8) command to set the altitude settings.
<Example 1> Specify an altitude of 1000 meters
XSCF> setaltitude -s altitude=1000
1000m
<Example 2> Specify an altitude of 200 meters
XSCF> setaltitude -s altitude=200
200m
Note – To apply the specified configuration, execute the rebootxscf (8) command
and reset XSCF.
lists setting items and the corresponding shell commands.
Command operation
Shell Command Remarks
showaltitude
A negative altitude
setaltitude
cannot be set.
Chapter 2 Setting Up XSCF 2-127