Fujitsu SPARC Enterprise M4000 User Manual page 84

Applying the XSCF Network Settings
Command operation
■
1. After performing the setnetwork (8), sethostname (8), setroute (8), and
setnameserver (8) commands, apply these Network settings.
2. Perform the applynetwork (8) command on the XSCF Shell. When
performing the command, the network settings are displayed and you can
confirm whether the settings should be applied.
XSCF> applynetwork
The following network settings will be applied:
xscf#0 hostname
DNS domain name
nameserver
interface
status
IP address
netmask
route
interface
status
IP address
netmask
route
Continue? [y|n] :y
Note – When the XSCF Unit is in redundant configuration, ISN addresses must be
in the same network subnet.
3. Use the rebootxscf (8) command to reset the XSCF and to complete the settings.
XSCF> rebootxscf
The XSCF will be reset. Continue? [y|n] :y
At this time, the window session is disconnected, so please reconnect to the XSCF
■
by using the new network interface and log in again.
4. Display the Network Configuration by using the shownetwork(8),
showhostname(8), showroute(8) and shownameserver(8) commands again
and check the new network information.
2-28 SPARC Enterprise Mx000 Servers XSCF User's Guide • April 2008
:scf0-hostname
:company.com
:10.0.0.2
:xscf#0-lan#0
:up
:192.168.1.10
:255.255.255.0
:-n 192.168.1.0 -m 255.255.255.0 -g 192.168.1.1
:xscf#0-lan#1
:down
:
:
: