Fujitsu SPARC Enterprise M4000 User Manual page 139

1. Use the showsnmpvacm (8) command to display VACM management
information.
XSCF> showsnmpvacm
Groups:
Groupname
---------------
xxxxx
Views
View
---------------
all_view
Access
View Group
---------------
all_view
2. Use the setsnmpvacm (8) command to set VACM management information.
<Example 1> Add a user to an access control group xxxxx.
XSCF> setsnmpvacm creategroup -u yyyyy xxxxx
<Example 2> Delete a user from an access control group xxxxx.
XSCF> setsnmpvacm deletegroup -u yyyyy xxxxx
<Example 3> Create an MIB access control view without conditions.
XSCF> setsnmpvacm createview -s .1 all_view
<Example 4> Create an MIB access control view by using an OID mask.
XSCF> setsnmpvacm createview -s .1.3.6.1.2.1 -m fe excl_view
<Example 5> Delete an MIB access control view.
XSCF> setsnmpvacm deleteview -s .1.3.6.1.2.1 excl_view
<Example 6> Provide an MIB access control view to a group.
XSCF> setsnmpvacm createaccess -r all_view xxxxx
<Example 7> Delete a group from all MIB access control views.
XSCF> setsnmpvacm deleteaccess group1
3. Use the showsnmpvacm (8) command to confirm the settings.
XSCF> showsnmpvacm
Username
-------------------
user1, user2
Subtree
-------------------
.1
-------------------
xxxxx
Mask Type
--------------- --------
ff include
Chapter 2 Setting Up XSCF 2-83