Specifying A Host Name For Xscf - Fujitsu SPARC Enterprise M4000 User Manual

Note – If you set a netmask using the -m option, this netmask value shows the
mask value in the XSCF network. A netmask value when you display the DSCP
network on the domain is not the netmask value in the XSCF network. The netmask
value for the domain DSCP address, which is displayed on the domain by using
ifconfig(1M), is a value set according to the setting of the network on the domain
side.
Note – All DSCP addresses must be in the same network subnet.

Specifying a Host Name for XSCF

Command operation
■
1. Use the showhostname (8) command to display host names.
XSCF> showhostname -a
xscf#0: scf-hostname0.company.com
xscf#1: scf-hostname1.company.com
2. Use the sethostname (8) command to specify a host name.
<Example 1> Specify the host name scf0-hostname for XSCFU#0.
XSCF> sethostname xscf#0 scf0-hostname
<Example 2> Specify the domain name com for XSCFU#0.
XSCF> sethostname -d company.com
Chapter 2 Setting Up XSCF 2-25