Fujitsu SPARC Enterprise M4000 User Manual page 73

Network Configuration (Continued)
TABLE 2-2
Item Description
Display route Displays the XSCF routing environment as
follows:
Network interface (see
Destination IP address, Gateway, netmask,
Flags.
The meanings of the Flags are as follows:
U : route is up
H : target is a host
G : use gateway
R : reinstate route for dynamic routing
C : cache entry
! : reject route
Add/delete Adds a route to or deletes a route from an
route XSCF network interface.
Specify the following:
• Network interface
• Destination IP address (Destination)
• Gateway
• netmask
Display DNS Displays XSCF name servers.
Add/delete DNS Add or delete the IP address of a name server.
Up to three name servers can be registered.
Names can be solved in the order specified.
Apply network Apply network settings.
Note – To complete the network settings, the XSCF reset is required. Reset the XSCF
by using the rebootxscf (8) command. After the XSCF is reset, the XSCF session is
disconnected. Please log in again to the XSCF.
),
TABLE 2-1
Shell Command Remarks
showroute
The setting of routing
setroute
information in each
interface can be set up to
eight respectively.
shownameserver
No default setting has
setnameserver
been specified.
If the DNS connection is
necessary, this setting is
done.
applynetwork
Chapter 2 Setting Up XSCF 2-17