Configuring Snmp Agent; Configuring Snmp Community - Fujitsu PRIMERGY BX900 Configuration Manual

17

Configuring SNMP Agent

This chapter describes how to configure SNMP agent which informs MIB information of SNMP
host.
17.1

Configuring SNMP Community

Beginning in privileged EXEC mode, follow these steps to configure SNMP v1/v2 agent
community:
Command
Step 1 configure
Step 2 snmp-server community
community-name1
Step 3 snmp-server community
community-name2
Step 4 snmp-server community rw
community-name2
Step 5 exit
Step 6 show snmp
To configure snmp community, use the snmp-server global configuration command. To
display the snmp configuration, use show snmp privileged EXEC command.
In this example, two snmp communities are created for read and read-write:
(BX900-CB1)(Config)#snmp-server community public
(BX900-CB1)(Config)#snmp-server community private
(BX900-CB1)(Config)#snmp-server community rw private
(BX900-CB1)(Config)#exit
(BX900-CB1)#show snmp
SNMP Community Name Client IP Address Client IP Mask
-------------------
public
private
(BX900-CB1)#
----------------- -----------------
0.0.0.0 0.0.0.0
0.0.0.0 0.0.0.0
2011 Fujitsu Technology Solutions
©
Purpose
Enter global configuration mode
Create a snmp community. The default
access mode is READ-ONLY.
Create another snmp community.
Set the access mode of the SNMP
community to READ-WRITE access mode..
Return to global configuration mode.
Verify the configuration.
Access Mode Status
-----------
Read Only
Read/Write
--------
Enable
Enable
59