Fujitsu SPARC Enterprise M4000 User Manual page 168

6. Use the showboards (8) command to discplay the XSB status again.
XSCF> showboards –va
XSB R DID(LSB) Assignment
---- - -------- ----------- ---- ---- ---- ------- -------- ----
00-0 02(00)
01-0 01(00)
01-1 SP
01-2 02(09)
01-3 02(10)
7. Use the poweron (8) command to start up the domain ID.
XSCF> poweron –a
DomainIDs to power on:01,02
Continue? [y|n] :y
01 :Powering on
02 :Powering on
*Note*
This command only issues the instruction to power-on.
The result of the instruction can be checked by the
"showlogs power".
8. Use the showboards (8) command to confirm that the XSB has been added to
domain ID 1.
XSCF> showboards –va
XSB R DID(LSB) Assignment
---- - -------- ----------- ---- ---- ---- ------- -------- ----
00-0 02(00)
01-0 01(00)
01-1 SP
01-2 02(09)
01-3 02(10)
Note – When moving the system board to the domain by using the DR function that
operates the XSB without stopping the domain, see the Dynamic Reconfiguration
User's Guide.
2-112 SPARC Enterprise Mx000 Servers XSCF User's Guide • April 2008
Pwr Conn Conf Test
Assigned n n
Assigned n n
Available n n
Assigned n n
Assigned n n
Pwr Conn Conf Test
Assigned y y
Assigned y y
Available y n
Assigned y y
Assigned y y
Fault
n Passed Normal
n Passed Normal
n Passed Normal
n Passed Normal
n Passed Normal
Fault
y Passed Normal
y Passed Normal
n Passed Normal
y Passed Normal
y Passed Normal
COD
n
n
n
n
n
COD
n
n
n
n
n