Configure Your Print Driver; Information Checklist; Procedure - Xerox 4250 - WorkCentre - Copier System Administration Manual

4 Print Drivers

Configure your Print Driver

Information Checklist

Before starting the Installation procedure, please ensure that the following items are
available and/or the tasks have been performed:
1. The appropriate printer driver should be installed on your Windows operating system.

Procedure

1. At your workstation, open your Printers folder.
2. Right-click on the printer.
3. Click on [Properties].
4. Click on [Configuration].
Bi-Directional Setup
1. The driver can be set to automatically obtain information on the installed hardware
options and status of the device.
2. Click on [Bi-Directional Setup].
3. Click on [Automatic] to have the driver automatically configure the IP address of the
device or click on [Manual] and enter the IP address or host name of the device.
4. If you want to change the default SNMP settings, click on [SNMP Community
Name] and enter the required information.
5. Click on the [OK] button.
Installable Options
1. If Bi-directional Setup is enabled, the driver will update with the options installed on
the device.
2. If Bi-directional setup is not enabled, select the options that are installed on your
device.
NOTE:
NOTE:
3. Click on the [OK] button.
Accounting
If you have an Accounting feature such as Xerox Standard Accounting or Network
Accounting installed, you can enable Accounting in the driver. For further information, see
Chapter 12, Network Accounting on page 107.
1. Click on the [OK] button to close your print driver Properties.
46
LAN Fax requires the Embedded Fax feature to be installed.
Job Storage requires the Save Job for Reprint feature to be enabled.
Xerox WorkCentre 4250/4260 Series System Administration Guide