Trigger:force - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

29
:TRIGger Commands

:TRIGger:FORCe

Command Syntax
:TRIGger:FORCe
The :TRIGger:FORCe command causes an acquisition to be captured even
though the trigger condition has not been met. This command is equivalent
to the front panel [Force Trigger] key.
See Also
•
592
(see page 790)
"Introduction to :TRIGger Commands"
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
on page 589