Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual page 37

Discontinued
Commands
Command
:ACQuire:RSIGnal
:CALibrate:SWITch?
:DISPlay:SOURce
:EXTernal:IMPedance
:EXTernal:PROBe:ID
:EXTernal:PROBe:STYPe
:EXTernal:PROTection
:HARDcopy:DEVice,
:HARDcopy:FORMat
:MERGe
:RECall:IMAGe[:STARt]
:SYSTem:PRECision
:TIMebase:REFClock
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
Description
The 2000 X-Series oscilloscope does not have a 10 MHz REF
BNC connector.
Replaced by :CALibrate:PROTected? (see
oscilloscope has a protection button instead of a switch.
PMEMory (pixel memory) locations are not present.
External TRIG IN connector is now fixed at 1 MOhm.
Not supported on external TRIG IN connector.
Not supported on external TRIG IN connector.
Not supported on external TRIG IN connector.
Use the :SAVE:IMAGe:FORMat, :SAVE:WAVeform:FORMat, and
:HARDcopy:APRinter commands instead.
Waveform traces have been replaced by reference waveforms.
Waveform traces have been replaced by reference waveforms.
The 2000 X-Series oscilloscopes' measurement record, and
maximum record size, is 62,500 points, and there is no need for a
special precision mode.
The 2000 X-Series oscilloscope does not have a 10 MHz REF
BNC connector.
1
What's New
page 212). The
37