Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual page 36

1
What's New
Command
:TRIGger:LEVel:HIGH (see
page
:TRIGger:LEVel:LOW (see
page
:TRIGger:PATTern Commands
(see
:WGEN Commands (see
page
:WMEMory<r> Commands
(see
Changed
Commands
Command
:ACQuire:MODE (see
page
:CALibrate:OUTPut (see
page
:DISPlay:DATA (see
:DISPlay:LABList (see
page
:DISPlay:VECTors (see
page
:MARKer Commands (see
page
:MEASure Commands (see
page
:SAVE:IMAGe[:STARt] (see
page
:TRIGger:PATTern (see
page
:WAVeform:SOURce (see
page
:VIEW (see
Obsolete
Commands
Obsolete Command
36
596)
597)
page 616)
663)
page 693)
187)
211)
page 258)
260)
262)
317)
333)
429)
617)
649)
page 182)
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
Description
Sets runt and transition (rise/fall time) trigger high level.
Sets runt and transition (rise/fall time) trigger low level.
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:DURation subsystem.
Commands for controlling the built-in waveform generator (with
Option WGN license).
Commands for reference waveforms.
Differences From InfiniiVision 7000B Series Oscilloscopes
There is no ETIMe parameter with the 2000 X-Series
oscilloscopes.
The TRIG OUT signal can be a trigger output, mask test failure,
or waveform generator sync pulse.
Monochrome TIFF images of the graticule cannot be saved or
restored.
The label list contains up to 77, 10-character labels (instead of
75).
Always ON with 2000 X-Series oscilloscopes.
Can select reference waveforms as marker source.
Can select reference waveforms as the source for many
measurements.
Cannot save images to internal locations.
Takes <string> parameter instead of <value>,<mask>
parameters.
Can select reference waveforms as the source.
PMEMory (pixel memory) locations are not present.
Current Command Equivalent Behavior Differences