Bus<N>:Label - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual
Oscilloscopes
Hide thumbs
Also See for InfiniiVision 2000 X-Series:
- User manual (296 pages) ,
- User manual (352 pages)
Table of Contents
Advertisement
8
:BUS<n> Commands
:BUS<n>:LABel
Command Syntax
:BUS<n>:LABel <quoted_string>
<quoted_string> ::= any series of 10 or less characters as a
quoted ASCII string.
<n> ::= An integer, 1 or 2, is attached as a suffix to BUS
and defines the bus that is affected by the command.
The :BUS<n>:LABel command sets the bus label to the quoted string.
Setting a label for a bus will also result in the name being added to the
label list.
This command is only valid for the MSO models.
N O T E
Label strings are 10 characters or less, and may contain any commonly used ASCII
N O T E
characters. Labels with more than 10 characters are truncated to 10 characters.
Query Syntax
:BUS<n>:LABel?
The :BUS<n>:LABel? query returns the name of the specified bus.
Return Format
<quoted_string><NL>
<quoted_string> ::= any series of 10 or less characters as a
quoted ASCII string.
See Also
•
•
•
•
•
•
•
•
•
Example Code
' Set the bus 1 label to "Data":
myScope.WriteString ":BUS1:LABel 'Data'"
204
(see
page
790)
"Introduction to :BUS<n> Commands"
":BUS<n>:BIT<m>"
on page 199
":BUS<n>:BITS"
on page 200
":BUS<n>:CLEar"
on page 202
":BUS<n>:DISPlay"
on page 203
":BUS<n>:MASK"
on page 205
":CHANnel<n>:LABel"
":DISPlay:LABList"
on page 260
":DIGital<d>:LABel"
on page 246
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
on page 198
on page 225
Advertisement
Table of Contents
