Function:source1 - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

:FUNCtion:SOURce1

Command Syntax
:FUNCtion:SOURce1 <value>
<value> ::= {CHANnel<n> | GOFT}
<n> ::= {1 | 2 | 3 | 4} for 4ch models
<n> ::= {1 | 2} for 2ch models
The :FUNCtion:SOURce1 command is used for any :FUNCtion:OPERation
selection (including the ADD, SUBTract, or MULTiply channel math
operations and the FFT transform). This command selects the first source
for channel math operations or the single source for the transforms.
The GOFT parameter is only available for the FFT function. It lets you
specify, as the function input source, the addition, subtraction, or
multiplication of two channels. When GOFT is used, the g(t) source is
specified by the :FUNCtion:GOFT:OPERation, :FUNCtion:GOFT:SOURce1,
and :FUNCtion:GOFT:SOURce2 commands.
Another shorthand notation for SOURce1 in this command/query (besides SOUR1) is
N O T E
SOUR.
Query Syntax
:FUNCtion:SOURce1?
The :FUNCtion:SOURce1? query returns the current source1 for function
operations.
Return Format
<value><NL>
<value> ::= {CHAN<n> | GOFT}
<n> ::= {1 | 2 | 3 | 4} for 4ch models
<n> ::= {1 | 2} for 2ch models
See Also
•
•
•
•
•
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
(see page 790)
"Introduction to :FUNCtion Commands"
":FUNCtion:OPERation"
":FUNCtion:GOFT:OPERation"
":FUNCtion:GOFT:SOURce1"
":FUNCtion:GOFT:SOURce2"
on page 278
on page 289
on page 285
on page 286
on page 287
16
:FUNCtion Commands
293