Sbus<N>:Spi:clock:timeout - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

:SBUS<n>:SPI:CLOCk:TIMeout
Command Syntax
:SBUS<n>:SPI:CLOCk:TIMeout <time_value>
<time_value> ::= time in seconds in NR3 format
The :SBUS<n>:SPI:CLOCk:TIMeout command sets the SPI signal clock
timeout resource in seconds from 100 ns to 10 s when the
:SBUS<n>:SPI:FRAMing command is set to TIMeout. The timer is used to
frame a signal by a clock timeout.
Query Syntax
:SBUS<n>:SPI:CLOCk:TIMeout?
The :SBUS<n>:SPI:CLOCk:TIMeout? query returns current SPI clock timeout
setting.
Return Format
<time value><NL>
<time_value> ::= time in seconds in NR3 format
See Also •
•
•
•
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
(see page 790)
"Introduction to :TRIGger Commands"
":SBUS<n>:SPI:CLOCk:SLOPe"
":SBUS<n>:SPI:SOURce:CLOCk"
":SBUS<n>:SPI:FRAMing"
on page 589
on page 496
on page 499
on page 498
25
:SBUS<n> Commands
497