Autoscale:amode - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

:AUToscale:AMODE

Command Syntax
:AUToscale:AMODE <value>
<value> ::= {NORMal | CURRent}
The :AUTOscale:AMODE command specifies the acquisition mode that is
set by subsequent :AUToscales.
• When NORMal is selected, an :AUToscale command sets the NORMal
• When CURRent is selected, the current acquisition type and mode are
Use the :ACQuire:TYPE and :ACQuire:MODE commands to set the
acquisition type and mode.
Query Syntax
:AUToscale:AMODE?
The :AUToscale:AMODE? query returns the autoscale acquire mode setting.
Return Format
<value><NL>
<value> ::= {NORM | CURR}
See Also
•
•
•
•
•
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
(see page 790)
acquisition type and the RTIMe (real- time) acquisition mode.
kept on subsequent :AUToscales.
"Introduction to Root (:) Commands"
":AUToscale" on page 153
":AUToscale:CHANnels"
":ACQuire:TYPE" on page 195
":ACQuire:MODE" on page 187
on page 150
on page 156
6
Root (:) Commands
155