Sbus<N>:Can:signal:baudrate - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

25
:SBUS<n> Commands
:SBUS<n>:CAN:SIGNal:BAUDrate
Command Syntax
:SBUS<n>:CAN:SIGNal:BAUDrate <baudrate>
<baudrate> ::= integer from 10000 to 4000000 in 100 b/s increments,
The :SBUS<n>:CAN:SIGNal:BAUDrate command sets the standard baud rate
of the CAN signal from 10 kb/s to 4 Mb/s in 100 b/s increments. If you
enter a baud rate that is not divisible by 100 b/s, the baud rate is set to
the nearest baud rate divisible by 100 b/s.
You can also set the baud rate of the CAN signal to 5 Mb/s. Fractional
baud rates between 4 Mb/s and 5 Mb/s are not allowed.
If the baud rate you select does not match the system baud rate, false
triggers may occur.
Query Syntax
:SBUS<n>:CAN:SIGNal:BAUDrate?
The :SBUS<n>:CAN:SIGNal:BAUDrate? query returns the current CAN baud
rate setting.
Return Format
<baudrate><NL>
<baudrate> ::= integer from 10000 to 4000000 in 100 b/s increments,
See Also
•
•
•
•
•
460
(see page 790)
or 5000000
or 5000000
"Introduction to :TRIGger Commands"
":SBUS<n>:MODE" on page 451
":SBUS<n>:CAN:TRIGger"
":SBUS<n>:CAN:SIGNal:DEFinition"
":SBUS<n>:CAN:SOURce"
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
on page 589
on page 463
on page 461
on page 462