33
Obsolete and Discontinued Commands
:MEASure:VDELta
Query Syntax
:MEASure:VDELta?
The :MEASure:VDELta? query returns the voltage difference between
vertical marker 1 (Y1 cursor) and vertical marker 2 (Y2 cursor). No
measurement is made when the :MEASure:VDELta? query is received by
the oscilloscope. The delta value that is returned is the current value. This
is the same value as the front- panel cursors delta Y value.
VDELta = value at marker 2 - value at marker 1
The :MEASure:VDELta command is an obsolete command provided for compatibility to
N O T E
previous oscilloscopes. Use the :MARKer:YDELta command (see
Return Format
<value><NL>
<value> ::= delta V value in NR1 format
See Also
•
•
•
•
•
•
•
734
(see
page
790)
"Introduction to :MARKer Commands"
"Introduction to :MEASure Commands"
":MARKer:Y1Position"
":MARKer:Y2Position"
":MARKer:YDELta"
on page 329
":MEASure:TDELta"
on page 727
":MEASure:TSTArt"
on page 729
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
on page 318
on page 340
on page 327
on page 328
page
329) instead.