I Start/Stop Scan - Icom IC-2710H Instruction Manual

I Scan start/stop
D Pre-operation
• Common setting: scan resume condition. (p. 46)
• For programmed scan: program the scan edges. (p. 43)
• For memory scan: program 2 or more memory chan-
nels; set memory skip settings, if de-
sired. (p. 45)
D Operation
➀
Push the desired band's tuning dial.
➁
Select VFO mode for full/programmed scan; or memory
mode for memory scan with the selected band's [V/MHz]
switch.
➂
Set the selected band's squelch to the point where noise
is muted.
➃
Push [ SCAN] for 1 sec. to start the scan.
(V/MHz)
• When the optional tone squelch is in use, [
the tone scan.
• To change the scanning direction, rotate the selected band's tun-
ing dial.
• The memory channel readout indicates the scan type as follows:
SCAN] starts
(V/MHz)
During full scan
Push SET L to select full scan
and scan edge
pairs in sequence.
➄
To select the scan range while operating full/programmed
scan, push [SET] several times.
➅
To stop the scan, push [
(VMHz)
Ä
Push [BAND] to select the desired band, if nec-
SCAN
essary.
2
Å
Push [VFO] to select VFO mode for full/pro-
grammed scan; or push [MR] to select memory
mode for memory scan.
Ç
Push [HYSQL] or [AZSQL] one or more times
to set the squelch just closed.
É
Push [➂SCAN] to start the scan.
• [Y]/[Z] also start the scan when pushed and held.
Ñ
To select the scan range while operating
full/programmed scan, push [SET] several
SET
times.
B
Ö
To stop the scan push [
SCAN OPERATION
During programmed scan
Indicates scan edge channels.
• P1 stands for 1A/1b.
• P1 to P3 are available when
they are programmed.
During memory scan
SCAN].
E
CLR].
9
42