Pager And Code Squelch; I Pager Function - Icom IC-2710H Instruction Manual
Dual band fm transceiver
Hide thumbs
Also See for IC-2710H:
- Service manual (71 pages) ,
- Step-by-step programming manual (2 pages) ,
- Service manual (48 pages)
Table of Contents
Advertisement
optional UT-49
I Pager function
The pager functions can be used only when an optional
UT-49 is installed. This function uses DTMF codes for paging
and can be used as a "message pager" to inform you of a
caller's identity even if you leave the transceiver temporarily
unattended.
Personal calls and group calls are available with the pager
function. Personal calls use the receiving parties' ID code for
calling. The receiving parties' display shows your ID code and
PAGER SIMULATION:
Personal call
No answer back
No pager
➀
111
➂
Answer
back
PAGER AND CODE SQUELCH
333/555
➀
222/555
➀
beep
➁
➀
beep
111/555
other stations in the party know that you called.
Group calls use the group code for calling. All station displays
show the group code and all stations know that someone in
your group called.
To use the pager function in your group, all stations need the
pager function.
PAGER SIMULATION:
Group call
No answer back
No pager
➀
➀
➀
555
➂
Answer
back
13
beep
➁
beep
333/555
➂
beep
➁
beep
222/555
➂
beep
➁
➀
beep
111/555
56
- Quick Links:
- Setting a Frequency
- I Crossband Full Duplex
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the IC-2710H and is the answer not in the manual?
Questions and answers
Set sub-audible tone to 67 Hz. How do I save it so that it transmits?
To save the sub-audible tone setting to 67 Hz on the Icom IC-2710H for transmission, follow these steps:
1. Enter the desired frequency and ensure the radio is in VFO mode.
2. Access the tone setting by pressing the appropriate button (e.g., [SET] or similar).
3. Navigate to the sub-audible tone frequency setting using the tuning dial.
4. Select 67.0 Hz as the tone frequency.
5. Exit the tone setting mode by pressing [ECLR] or the tuning dial.
6. To save the tone setting permanently, overwrite the memory channel with the updated settings.
Note: If you do not overwrite the memory channel, the tone setting will be cleared when switching to memory/call mode.
This answer is automatically generated