I Programming A Memory Channel - Icom IC-2710H Instruction Manual

6
MEMORY OPERATION

I Programming a memory channel

VFO mode settings, including the set mode contents such as
subaudible tone frequency, etc., are programmed into a mem-
ory channel.
➀
Set the desired frequency in VFO mode:
➥ Push the desired band's [V/MHz] to select VFO mode.
➥ Set the frequency using the desired band's tuning dial.
➥ Set other data (e.g. tone frequency, etc.) if required.
➁
Push [S.MW] momentarily.
• "!" and the memory channel number flashes.
➂
Rotate the tuning dial to select the memory channel to be
[EXAMPLE]: Programming 145.870 MHz into memory channel 20 via the remote controller.
Push and
Rotate
33
Rotate
V/MHz
SCAN
1 5 9
Push
S.MW MW
programmed.
• Memory channels not yet programmed are blank.
➃
Push [S.MW] for 1 sec. to program.
• 3 beeps may sound.
• Memory channel number automatically advances when continu-
ing to push [S.MW] after programming.
✔ CONVENIENT
Memory programming can be performed in versatile ways
e.g. memory channel to the same (or different) memory chan-
nel, memory channel to the call channel, etc.
for setting Push
freq., etc.
1 5 9
for 1 sec. and continue pushing
S.MW MW momentarily
1 5 9