I Operation - Icom IC-2710H Instruction Manual

5
REPEATER OPERATION

I Operation

➀
Push the desired band's tuning dial.
➁
Set the receive frequency (repeater output frequency).
(pgs. 15–19)
➂
Push and hold [DUP] to select – duplex or push it for 1 sec.
again for + duplex.
• "DUP –" or "DUP" appears to indicate the transmit frequency for
minus shift or plus shift, respectively.
• When the auto repeater function is turned ON, (available for the
U.S.A. version only), steps ➁ and ➂ are not necessary. (p. 31)
DUP –
➃ Push and hold [
encoder, according to repeater requirements.
• Refer to p. 29 for tone frequency settings.
• When the repeater requires a different tone system, see the page
at right.
DUP – T
27
T] to turn ON the subaudible tone
(DTMF)
➄
Push and hold [PTT] to transmit.
• The displayed frequency automatically changes to the transmit
frequency (repeater input frequency).
• The operating condition is automatically programmed into a
scratch pad memory. See p. 39 for details.
• If "oFF" appears, confirm the offset frequency. (p. 30)
➅
Release [PTT] to receive.
➆ Push the selected band's [MONI] to check whether the
other station's transmit signal can be directly received or
not.
➇
To return to simplex, push [DUP] for 1 sec., once or twice,
to clear the "DUP" indicator.
➈
To turn OFF the subaudible tone encoder, push and hold
[ T].
(DTMF)
• "T" disappears.
• When the optional UT-104 is installed, push and hold [
an additional 2 times (for a total of 3 times).
T]
(DTMF)