I Ex-1759 Installation - Icom IC-2710H Instruction Manual
Dual band fm transceiver
Hide thumbs
Also See for IC-2710H:
- Service manual (71 pages) ,
- Step-by-step programming manual (2 pages) ,
- Service manual (48 pages)
Table of Contents
Advertisement
16
WIRELESS OPERATION
I EX-1759 installation
The EX-1759
INFRARED RECEIVER
ent purposes depending on the HM-90 charger. This is be-
cause the EX-1759 has both an infrared receiver and a
microphone connector which contains microphone charging
capabilities.
• When using the BC-96 with external DC input
Attach the EX-1759 to a suitable location for receiving in-
frared signals, e.g. sunvisor, etc.
• When using the connector for a microphone charger
Attach the EX-1759 to a suitable location for receiving in-
frared signals and where it can be connected to a cable, e.g.
the console, etc.
NOTE: DO NOT attach the EX-1759 where it will be sub-
ject to direct sunlight as it cannot detect infrared signals
under such conditions.
67
can be installed for 2 differ-
EX-1759
The installation clip can be oriented in 1 of 4 ways.
• Optional infrared sub receiver
An optional EX-1513
INFRARED SUB RECEIVER
increase the remote control reliablility and extend the control-
lable area. Connect the EX-1513 to the inside connector of
the EX-1759.
NOTE: The supplied microphone, HM-98, can be con-
nected and used with the EX-1759, however, the optional
wireless microphone cannot be used in such a case.
(When using BC-96
with external DC)
(When using the mic
connector for mic
charging.)
is available to
- Quick Links:
- Setting a Frequency
- I Crossband Full Duplex
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the IC-2710H and is the answer not in the manual?
Questions and answers
Set sub-audible tone to 67 Hz. How do I save it so that it transmits?
To save the sub-audible tone setting to 67 Hz on the Icom IC-2710H for transmission, follow these steps:
1. Enter the desired frequency and ensure the radio is in VFO mode.
2. Access the tone setting by pressing the appropriate button (e.g., [SET] or similar).
3. Navigate to the sub-audible tone frequency setting using the tuning dial.
4. Select 67.0 Hz as the tone frequency.
5. Exit the tone setting mode by pressing [ECLR] or the tuning dial.
6. To save the tone setting permanently, overwrite the memory channel with the updated settings.
Note: If you do not overwrite the memory channel, the tone setting will be cleared when switching to memory/call mode.
This answer is automatically generated