I Programming A Call Channel; Call Channel Operation - Icom IC-2710H Instruction Manual

I Programming a call channel

In addition to an operating frequency, duplex information and
subaudible tone information (tone encoder or tone squelch*
ON/OFF and its frequency) can be programmed into the call
channel.
*An optional UT-104 is necessary.
➀
Push the desired band's tuning dial.
➁
Select the call channel by pushing the selected band's
[M/CALL] once or twice. (A large "C" appears.)
➂
Set the desired frequency in VFO mode:
➥ Push [VFO] to select VFO mode.
➥ Set the frequency using the keypad.
➥ Set other data (e.g. offset frequency, duplex direction, subaudi-
ble tone encoder ON/OFF and its frequency), if required.
➃
Push [ MW] for 1 sec. to program.
(S.MW)
[EXAMPLE]: Programming 145.120 MHz into the VHF call channel via the microphone.
BAND
for 1 sec.
CALL
MR
Call channel
✔ CONVENIENT
The call channel can also be programmed from the VFO di-
rectly (similar to memory programming).
Ä
Push [BAND] to select the desired band, if nec-
MW
essary.
A
Å
Push [
channel.
Ç
Set the desired frequency in VFO mode:
• Push [VFO] to select VFO mode.
• Set the desired frequency using the keypad.
• Set other data, if required.
É
Push [FUNC] then [EMW] for 1 sec. to pro-
gram.
C
ENT
VFO
VFO mode

CALL CHANNEL OPERATION

CALL] for 1 sec. to select the call
(MR)
1
MONI
4 5
HIGH MID
1 2
MONI SCAN FUNC
then
7
MW
A
CLR
for 1 sec.
Beep
Beep
Beep
38