I Programming Scan Edges Via The Microphone - Icom IC-2710H Instruction Manual
Dual band fm transceiver
Hide thumbs
Also See for IC-2710H:
- Service manual (71 pages) ,
- Step-by-step programming manual (2 pages) ,
- Service manual (48 pages)
Table of Contents
Advertisement
I Programming scan edges via
the microphone
Ä
Push [BAND] to select the desired band, if nec-
MW
essary.
A
Å
Set the desired frequency in VFO mode:
➥ Push [VFO] to select VFO mode.
➥ Set the frequency using the keypad.
Ç
Push [FUNC] then [EMW] momentarily.
É
Push [Y] or [Z] to select scan edge channels.
Ñ
Push [FUNC] then [EMW] for 1 sec. to pro-
gram.
[EXAMPLE]: Programming 145.30 MHz and 145.80 MHz for the VHF scan edges 1A and 1b.
Push
VFO
1
5
9
Push
1
4
5
MONI
HIGH
MID
C
ENT
Y
3
0
PRIO
VOL
1
5
MW
then
Push
for 1 sec. and
FUNC
A
CLR
➥ 3 beeps may sound and the VFO contents (including the sub-
audible tone frequency, etc.) are programmed.
➥ Memory channel number advances to the next scan edge chan-
nel (1b to 3b) when continuing to push [EMW] after program-
ming.
Ö
To program a frequency for the other scan edge channel,
repeat steps Å
Ñ
and
.
Push
then
FUNC
9
continue pushing
9
SCAN OPERATION
MW
A
CLR
momentarily
1
5
9
Program 1b
in the same
manner.
44
- Quick Links:
- Setting a Frequency
- I Crossband Full Duplex
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the IC-2710H and is the answer not in the manual?
Questions and answers
Set sub-audible tone to 67 Hz. How do I save it so that it transmits?
To save the sub-audible tone setting to 67 Hz on the Icom IC-2710H for transmission, follow these steps:
1. Enter the desired frequency and ensure the radio is in VFO mode.
2. Access the tone setting by pressing the appropriate button (e.g., [SET] or similar).
3. Navigate to the sub-audible tone frequency setting using the tuning dial.
4. Select 67.0 Hz as the tone frequency.
5. Exit the tone setting mode by pressing [ECLR] or the tuning dial.
6. To save the tone setting permanently, overwrite the memory channel with the updated settings.
Note: If you do not overwrite the memory channel, the tone setting will be cleared when switching to memory/call mode.
This answer is automatically generated