I Sub Band Mute/Sub Band Busy Beep - Icom IC-2710H Instruction Manual
Dual band fm transceiver
Hide thumbs
Also See for IC-2710H:
- Service manual (71 pages) ,
- Step-by-step programming manual (2 pages) ,
- Service manual (48 pages)
Table of Contents
Advertisement
4
BASIC OPERATION
I Sub band mute/
sub band busy beep
The sub band mute function automatically cuts out sub band
AF signals when both main and sub band signals are re-
ceived simultaneously.
The sub band busy beep sounds when the sub band's
squelch is closed to inform you that the sub band's squelch
has been opened.
Common setting for each band
➀
While pushing [
ceiver), push [POWER] to enter initial set mode.
➁
Push [SET] one or more times until "Sub" appears in the
display as shown above.
• Push [MONI] to reverse the order of selection.
23
INITIAL SET MODE
USING
The display shows that the sub
band mute is turned ON and
the sub band busy beep is
turned OFF.
SET L] (on the left side of the trans-
(VOL)
➂
Rotate the main band's tuning dial to set the condition.
DISPLAY
SUB BAND MUTE
Sub-oF
OFF
Sub-oF S
OFF
Sub-on
Sub-on S
➃
Push [POWER] momentarily to exit initial set mode.
BUSY BEEP
OFF
ON
ON
OFF
ON
ON
- Quick Links:
- Setting a Frequency
- I Crossband Full Duplex
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the IC-2710H and is the answer not in the manual?
Questions and answers
Set sub-audible tone to 67 Hz. How do I save it so that it transmits?
To save the sub-audible tone setting to 67 Hz on the Icom IC-2710H for transmission, follow these steps:
1. Enter the desired frequency and ensure the radio is in VFO mode.
2. Access the tone setting by pressing the appropriate button (e.g., [SET] or similar).
3. Navigate to the sub-audible tone frequency setting using the tuning dial.
4. Select 67.0 Hz as the tone frequency.
5. Exit the tone setting mode by pressing [ECLR] or the tuning dial.
6. To save the tone setting permanently, overwrite the memory channel with the updated settings.
Note: If you do not overwrite the memory channel, the tone setting will be cleared when switching to memory/call mode.
This answer is automatically generated