Call Channel Operation; I Calling Up A Call Channel Contents; I Transferring Call Channel Contents - Icom IC-2710H Instruction Manual
Dual band fm transceiver
Hide thumbs
Also See for IC-2710H:
- Service manual (71 pages) ,
- Step-by-step programming manual (2 pages) ,
- Service manual (48 pages)
Table of Contents
Advertisement
7
CALL CHANNEL OPERATION
I Calling up a call channel
Each band has an independent call channel to store a most-
often-used frequency for quick recall.
➀
Push the desired band's [M/CALL] once or twice to display
a large "C" in the memory channel readout.
• To transmit on the call channel, select the desired band as the
main band in advance.
➁
Push the same band's [V/MHz] or [M/CALL] to exit the call
channel.
Large "C" shows the call
channel is selected.
Ä
Push [BAND] to select the desired band, if nec-
CALL
essary.
Å
Push [
channel.
37
Small "c" shows VFO mode
was selected from the call
channel.
CALL] for 1 sec. to select the call
(MR)
I Transferring call channel
contents
➀
Push the desired band's tuning dial.
➁
Select the call channel by pushing the selected band's
[M/CALL] once or twice.
• A large "C" appears.
➂
Push [S.MW] momentarily, then rotate the tuning dial to se-
lect another memory channel to transfer.
• To transfer to the VFO, push and hold [
pushing momentarily.
➃
Push and hold [
MW] to transfer when a momentary
(S.MW)
push was used in the previous step.
Ä
Push [BAND] to select the desired band, if nec-
MW
essary.
A
Å
Push [
CALL] for 1 sec. to select the call
(MR)
channel.
Ç
Push [FUNC], then [EMW] momentarily.
• To transfer to the VFO, push [FUNC] then [EMW] in-
stead of pushing [EMW] momentarily.
É
Push [FUNC] then [EMW] for 1 sec. to transfer
when momentarily pushing [EMW] in step ➂.
MW] instead of
(S.MW)
- Quick Links:
- Setting a Frequency
- I Crossband Full Duplex
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the IC-2710H and is the answer not in the manual?
Questions and answers
Set sub-audible tone to 67 Hz. How do I save it so that it transmits?
To save the sub-audible tone setting to 67 Hz on the Icom IC-2710H for transmission, follow these steps:
1. Enter the desired frequency and ensure the radio is in VFO mode.
2. Access the tone setting by pressing the appropriate button (e.g., [SET] or similar).
3. Navigate to the sub-audible tone frequency setting using the tuning dial.
4. Select 67.0 Hz as the tone frequency.
5. Exit the tone setting mode by pressing [ECLR] or the tuning dial.
6. To save the tone setting permanently, overwrite the memory channel with the updated settings.
Note: If you do not overwrite the memory channel, the tone setting will be cleared when switching to memory/call mode.
This answer is automatically generated