Memory Operation; I General Description; I Memory Channel Selection - Icom IC-2710H Instruction Manual

I General description

The transceiver has 99 regular memory channels plus 6 scan
edge memory channels (3 pairs) on each band; each of these
can be individually programmed with the following data.
• Operating frequency (pgs. 15–19)
• Duplex direction (DUP or DUP–) and its offset frequency
(pgs. 27, 30)
• Subaudible tone encoder or tone squelch*
quency (pgs. 27, 29)
2
• Skip information* (p. 45)
1
* An optional UT-104
TONE SQUELCH UNIT
2
* Except for the scan edge memory channels.
1
and its tone fre-
is necessary.

MEMORY OPERATION

I Memory channel selection

D Using a tuning dial
➀
Push the desired band's [M/CALL] once or twice to display
"!".
➁
Rotate the same band's tuning dial to select the desired
memory channel.
• Only the programmed memory can be selected.
D Using [Y]/[Z] switches
Ä
Push [BAND] to select the desired band, if nec-
MR
essary.
Å
Push [MR] to select memory mode.
Ç
Push [Y] or [Z] several times to select the de-
Y/Z
sired memory channel.
• Pushing [Y]/[Z] more than 0.5 sec. activates a scan.
• If a scan is activated, push [Y] or [Z] again to stop it.
D Using the keypad
Ä
Push [BAND] to select the desired band, if necessary.
Å
MR
Push [MR] to select memory mode.
Ç
Push [GENT] to activate the keypad for numeral input.
É
Push 2 appropriate digit keys to input a channel
ENT
number.
C
• When inputting non-programmed channel numbers
the previous memory channel appears.
• To select scan edge channels, "B" and "A" can be
used for A and b respectively.
6
32