I Skip Channel Setting - Icom IC-2710H Instruction Manual

9
SCAN OPERATION

I Skip channel setting

The memory skip function speeds up scanning by checking
only desired memory channels. Set the memory channels to
be skipped or scanned as follows.
Separate setting for each band
➀
Push the desired band's tuning dial.
➁
Select the memory channel to program or to cancel the
skip function on:
➥ Select memory mode by pushing the selected band's [M/CALL]
once or twice.
➥ Rotate the selected band's tuning dial to select the memory
channel.
➂
Push [SET] one or more times until "CHS" appears as
shown above.
• Pushing [MONI] reverses the order of selection.
➃
Rotate the selected band's tuning dial to turn the skip func-
tion ON or OFF on the selected channel.
• "~" appears
(CHS-on)
• "~" disappears
(CHS-OFF)
45
USING
The display shows that VHF
memory channel 10 is set as
a skip channel.
SKIP
: The memory channel is skipped during
memory scan.
: The memory channel is scanned during
memory scan.
➄
Push the selected band's tuning dial to exit set mode.
SET MODE
NOTE: Scan edge memory channels cannot be specified
as skip channels, however, they are skipped during mem-
ory scan anyway.
Ä
SET
B
Å
Ç
É
Ñ
Push [BAND] to select the desired band, if nec-
essary.
Select the memory channel to program or to
cancel the skip function on:
➥ Select memory mode by pushing [MR].
➥ Push [Y] or [Z] to select a memory channel.
Push [FSET] one or more times until "CHS" ap-
pears as shown at left.
• Pushing [GENT] reverses the order of selection
once entering set mode.
Push [Y] or [Z] to set or cancel the skip infor-
mation.
• See item ➃ at left for skip indicator details.
Push [ECLR] to exit set mode.