I Scan Start/Stop - Icom IC-2725E Instruction Manual

I Scan start/stop

D Preparation
Scan resume condition (p. 44); program the scan edges
(pgs. 41, 42); program 2 or more memory channels (pgs. 29,
30); set skip settings, if desired (p. 43).
D Operation
q Select VFO mode for full/programmed scan with
[V/MHz•SCAN]; or memory mode for memory scan with
[M/CALL•MW] in the desired band.
• Select the desired bank with the same band's [MAIN•BAND] for
bank scan.
w Set the squelch to the point where noise is just muted.
e Push the [V/MHz•SCAN] for 1 sec. to start the scan.
• To change the scanning direction, rotate the same band's [DIAL].
• The memory channel readout blinks the scan type as follows:
r Push [SET•
] to switch full and programmed scan (P1,
P2, P3, P4 and P5), if VFO is selected in step q.
t To stop the scan, push the [V/MHz•SCAN].
• During full scan
MAIN
T X
M
Push [SET• ] to select "AL"
(full) or programmed scan (P1,
P2, P3, P4 and P5) in
sequence.
• During programmed scan
MAIN
T X
M
Indicates scan edge channels.
• P1 stands for 1A/1b
• P1 to P5 are available when they
are programmed, and switches
with [SET• ].
SCAN OPERATION
z Push [VFO/LOCK] to select VFO mode for
SCAN
full/programmed scan; push [MR/CALL] to select
2
memory mode for memory scan, in the main
band.
SET
• Push [FUNC] then [
B
for bank scan.
x Push [
D(MUTE)] or [
Y
SQL
set the squelch to the point where noise is just
muted.
c Push [
2(T-SCAN)] to start the scan.
SCAN
• Push [Y] or [Z] for 1 sec. also starts the scan.
v Push [
B(D-OFF)] to switch full and pro-
SET
grammed scan (P1, P2, P3, P4 and P5), if VFO
is selected in step z.
b To stop the scan push [
[ A(MW)].
CLR
• During memory scan
MAIN
T X
M
7
1(BANK)] to select a bank
MONI
#(16KEY-L)] to
Z
SQL
2(T-SCAN)] or
SCAN
• During bank scan
MAIN
T X
M
Indicates bank initial.
7
40