I Microphone Keypad - Icom IC-2710H Instruction Manual
Dual band fm transceiver
Hide thumbs
Also See for IC-2710H:
- Service manual (71 pages) ,
- Step-by-step programming manual (2 pages) ,
- Service manual (48 pages)
Table of Contents
Advertisement
1
PANEL DESCRIPTION
I Microphone keypad
KEY
Toggles between opening and closing the
AFC
1
accessed band's squelch.
MONI
AFC-OFF
• Starts and stops scanning.
2
SCAN
• Starts tone scan when an optional tone
squelch is in use.
PTT-M
Starts and stops priority watch.
3
PRIO
PGR
Selects high output power.
4
HIGH
CSQL
Selects middle output power.
5
MID
DTMF
Selects low output power.
6
LOW
TONE
Selects –duplex.
7
DUP–
TSQLS
Selects +duplex.
8
DUP+
TSQL
Selects simplex
9
SIMP
TONE-2
Increases the audio output.
0
VOL
7
FUNCTION
(p. 20)
(p. 42)
(p. 55)
(p. 48)
(p. 26) Turns the optional pager function ON.(p. 59)
(p. 26) Turns the optional code squelch function
(p. 26) Turns the DTMF memory encoder function
(p. 28) Turns the subaudible tone encoder ON.
(p. 28) Turns the optional pocket beep function ON.
(p. 28) Turns the optional tone squelch function
(p. 20) While being pushed, transmits a 1750 Hz
SECONDARY FUNCTION (after
No secondary function.
No secondary function.
Turns the one-touch PTT function ON and
OFF.
ON.
ON.
ON.
tone.
OTHER FUNCTIONS
FUNC
)
(p. 26)
DTMF-S
After
:
Transmit the appropriate
DTMF code or push [1] to
(p. 62)
[8] to transmit the DTMF
memory contents when
(p. 50)
the DTMF memory en-
coder is activated. (p. 51)
(p. 28)
(p. 53)
(p. 54)
(p. 28)
- Quick Links:
- Setting a Frequency
- I Crossband Full Duplex
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the IC-2710H and is the answer not in the manual?
Questions and answers
Set sub-audible tone to 67 Hz. How do I save it so that it transmits?
To save the sub-audible tone setting to 67 Hz on the Icom IC-2710H for transmission, follow these steps:
1. Enter the desired frequency and ensure the radio is in VFO mode.
2. Access the tone setting by pressing the appropriate button (e.g., [SET] or similar).
3. Navigate to the sub-audible tone frequency setting using the tuning dial.
4. Select 67.0 Hz as the tone frequency.
5. Exit the tone setting mode by pressing [ECLR] or the tuning dial.
6. To save the tone setting permanently, overwrite the memory channel with the updated settings.
Note: If you do not overwrite the memory channel, the tone setting will be cleared when switching to memory/call mode.
This answer is automatically generated