External Dtmf Remote - Icom IC-2710H Instruction Manual
Dual band fm transceiver
Hide thumbs
Also See for IC-2710H:
- Service manual (71 pages) ,
- Step-by-step programming manual (2 pages) ,
- Service manual (48 pages)
Table of Contents
Advertisement
CALL MR VFO CLR
1
2
3
A
HIGH
4
5
6
B
LOW1
7
8
9
C
DOWN
UP ENT
M
#
0
D
DTMF KEYPAD
[EXAMPLE]: Setting the operating frequency to 145.8125 MHz (when the VHF tuning step is 12.5 kHz).
B
1
Password
(if programmed)
[EXAMPLE]
144.750 MHz
Memory channel 15
Scratch pad
memory 2
Note for the [ENT] key
• When the entered frequency is outside of the frequency coverage, the input
digits will be cleared.
• To adjust the frequency less than 10 kHz or to select a scan edge memory
channel (1A, 1b), use the [UP] or [DOWN] key.
#
2
3
3
D
(or "F")
VFO
[ENT]
mode
EXTERNAL DTMF REMOTE
3
D
1
4
VFO
[ENT]
100
10
mode
MHz
MHz
2
D
1
5
Memory
[ENT]
mode
2 digits
M
M
1
Call
[DOWN] [DOWN]
channel
#
1
4
5
8
0
(UP)
Frequency setting
4
7
5
1 MHz 100
10 kHz
kHz
M
B
(or "E")
14
64
- Quick Links:
- Setting a Frequency
- I Crossband Full Duplex
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the IC-2710H and is the answer not in the manual?
Questions and answers
Set sub-audible tone to 67 Hz. How do I save it so that it transmits?
To save the sub-audible tone setting to 67 Hz on the Icom IC-2710H for transmission, follow these steps:
1. Enter the desired frequency and ensure the radio is in VFO mode.
2. Access the tone setting by pressing the appropriate button (e.g., [SET] or similar).
3. Navigate to the sub-audible tone frequency setting using the tuning dial.
4. Select 67.0 Hz as the tone frequency.
5. Exit the tone setting mode by pressing [ECLR] or the tuning dial.
6. To save the tone setting permanently, overwrite the memory channel with the updated settings.
Note: If you do not overwrite the memory channel, the tone setting will be cleared when switching to memory/call mode.
This answer is automatically generated