I Sub Band Access - Icom IC-2710H Instruction Manual
Dual band fm transceiver
Hide thumbs
Also See for IC-2710H:
- Service manual (71 pages) ,
- Step-by-step programming manual (2 pages) ,
- Service manual (48 pages)
Table of Contents
Advertisement
I Sub band access
This function allows you to change sub band settings such as
duplex settings, especially useful from the microphone, during
transmission standby on the main band.
It's easy to access the sub band and return to the main band
with the band switch.
➀
Push and hold the sub band's tuning dial until "^" ap-
pears as shown below.
• If the [PTT] is pushed at this time, transmit is on the main band.
• If the main band's tuning dial is mistakenly pushed and held, the
para-watch function is activated. In this case, push the main
band's tuning dial for 1 sec. and repeat ➀ again. (p. 24)
➁
Activate functions such as duplex setting, subaudible
tones, etc.
➂
To exit sub band access, push the main band's tuning dial.
• To switch from the sub band to the main band, push the sub
band's tuning dial.
• Pushing and holding the sub band's tuning dial until "
appears also exits sub band access.
"^" appears
^
" dis-
The sub band access function is also available from the mi-
crophone and is useful for setting the sub band's frequency,
etc. during transmission standby on the main band.
Ä
Push and hold [
BAND
• "^" appears.
• If the [PTT] is pushed at this time, transmit is on the
main band.
Å
Set the sub band's operating frequency or acti-
vate functions.
Ç
To exit sub band access, push and hold
[
SUB] again.
(BAND)
• "^" disappears.
• To switch from the sub band to the main band (for
transmitting), push
BASIC OPERATION
SUB].
(BAND)
SUB] (momentarily).
[(BAND)
4
22
- Quick Links:
- Setting a Frequency
- I Crossband Full Duplex
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the IC-2710H and is the answer not in the manual?
Questions and answers
Set sub-audible tone to 67 Hz. How do I save it so that it transmits?
To save the sub-audible tone setting to 67 Hz on the Icom IC-2710H for transmission, follow these steps:
1. Enter the desired frequency and ensure the radio is in VFO mode.
2. Access the tone setting by pressing the appropriate button (e.g., [SET] or similar).
3. Navigate to the sub-audible tone frequency setting using the tuning dial.
4. Select 67.0 Hz as the tone frequency.
5. Exit the tone setting mode by pressing [ECLR] or the tuning dial.
6. To save the tone setting permanently, overwrite the memory channel with the updated settings.
Note: If you do not overwrite the memory channel, the tone setting will be cleared when switching to memory/call mode.
This answer is automatically generated