I Scan Start/Stop - Icom IC-207H Instruction Manual

9
SCAN OPERATION

I Scan start/stop

D Pre-operation
• Common setting:
• For programmed scan: program the scan edges. (p. 40)
• For memory scan:
D Operation
➀
Push [BAND] to select a band, if necessary.
➁
Select VFO mode for full/programmed scan with the
[V/MHz] switch; or memory mode for memory scan with the
[M/CALL] switch.
➂
Set the squelch to the point where noise is muted.
➃
Push for 1 sec. to start the scan.
SCAN
• When the tone squelch is in use,
not tone scan.
• To change the scanning direction, rotate the tuning dial.
• The memory channel readout indicates the scan type as follows:
H I
39
scan resume condition. (p. 43)
program 2 or more memory chan-
nels; set memory skip settings, if de-
sired. (p. 42)
starts a normal scan—
SCAN
During full scan
9
5
1
Push
to select full scans
BAND
and scan edge
pairs in sequence.
H I
5
1
H I 5
1
M
➄
To select the scan range while operating full/programmed
scan, push [BAND] several times.
➅
To stop the scan, push [VMHz].
Ä
Push [BAND] to select the desired band, if nec-
SCAN
essary.
2
Å
Push [VFO] to select VFO mode for full/pro-
grammed scan; or push [MR] to select memory
mode for memory scan.
Ç
Push [HYSQL] or [AZSQL] one or more times
to set the squelch just closed.
É
Push [➂SCAN] to start the scan.
• [Y]/[Z] also start the scan when pushed and held.
BAND
Ñ
To select the scan range while operating
full/programmed scan, push [BAND] several
times.
Ö
To stop the scan push [
During programmed scan
9
Indicates scan edge channels.
• P1 stands for 1A/1b.
• P1 to P5 are available when
they are programmed.
9
During memory scan
E
CLR].