Table of Contents
Advertisement
■ Scan start/stop
D Preparation
Scan resume condition
(p. 77)
; program 2 or more memory channels
(pgs. 75, 76)
; set skip settings, if desired
62)
D Operation
qSelect VFO mode for full/programmed scan with
[V/MHz•SCAN]; or memory mode for memory scan with
[M/CALL•MW] in the desired band
• Select the desired bank with the same band's [MAIN•BAND] for
bank scan.
w Push and hold the same band's [V/MHz•SCAN] for 1 sec.
eRotate the same band's [DIAL] to select the scan type
from ALL and programmed scan
VFO is selected in step q.
rPush the same band's [V/MHz•SCAN] momentarily to start
the scan.
• To change the scanning direction, rotate the same band's [DIAL].
• The memory channel readout blinks the scan type as follows:
• During full scan
Rotate [DIAL] to select "ALL"
(full) or programmed scan (P1
to P9) in sequence.
; program the scan edges
(pgs. 61,
.
(p. 78)
.
(Left or Right)
, if
(PROG 0 to PROG 9)
• During programmed scan
Indicates scan edge channels.
• P1 stands for 1A/1B
tTo stop the scan, push the same band's [V/MHz•SCAN].
z Push [VFO/LOCK] to select VFO mode for
SCAN
full/programmed scan; push [MR/CALL] to select
2
memory mode for memory scan, in the main
band.
• Push [FUNC] then [
for bank scan.
x Push [
2(T-SCAN)].
SCAN
c Push [Y] or [Z] to select the ALL and pro-
grammed scan
(PROG 0 to PROG 9)
lected in step z.
v Push [
2(T-SCAN)] again to start the scan.
SCAN
• Push [Y] or [Z] for 1 sec. also starts the scan.
b To stop the scan push [
[
A(MW)].
CLR
• During memory scan
SCAN OPERATION
1(BANK)] to select a bank
MONI
, if VFO is se-
2(T-SCAN)] or
SCAN
• During bank scan
Indicates bank initial.
8
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
74
Advertisement
Table of Contents
