I Scan Start/Stop - Icom ID-800H Instruction Manual

7
SCAN OPERATION

I Scan start/stop

D Preparation
Scan resume condition
; program 2 or more memory channels
(pgs. 45, 46)
; set skip settings
30)
• During full scan
Push [SET•LOCK] to select
full (ALL), band* (A-8, A-5, A-
4, A-3, A-2, A-1, A-A) or pro-
grammed scan (P1, P2, P3,
P4 and P5) in sequence.
(*Depends on versions)
43
; program the scan edges
(p. 48)
, if desired.
(p. 47)
• During programmed scan
Indicates scan edge channels.
• P1 stands for 1A/1B
• P1 to P5 are available when
they are programmed, and
switches with [SET•LOCK].
D Operation
q Select VFO mode for full/programmed scan with
[V/MHz•SCAN]; or memory mode for memory scan with
(pgs. 29,
[M/CALL•PRIO].
• Select the desired bank for bank scan.
w Set the squelch to the point where noise is just muted.
e Push and hold [V/MHz•SCAN] for 1 sec. to start the scan.
• To change the scanning direction, rotate [DIAL].
• The memory channel readout blinks the scan type as follows:
r Push [SET•LOCK] to switch full and programmed scan
(P1, P2, P3, P4 and P5), if VFO is selected in step q.
t To stop the scan, push [V/MHz•SCAN].
• During memory scan • During bank scan
Indicates bank initial.