I Scan Start/Stop - Icom IC-2200H Instruction Manual

I Scan start/stop

D Preparation
Scan resume condition (p. 42); program the scan edges
(pgs. 39, 40); program 2 or more memory channels (pgs. 25,
26); set skip settings, if desired (p. 41).
D Operation
q Select VFO mode for full/programmed scan with
[V/MHz SCAN ]; or memory mode for memory scan with
[M/CALL PRIO ].
• Select the desired bank with [BANK
w Set the squelch to the point where noise is just muted.
e Push [V/MHz
SCAN ] for 1 sec. to start the scan.
• To change the scanning direction, rotate [DIAL].
• The memory channel readout blinks the scan type as follows:
r Push [SET
LOCK ] to switch full and programmed scan
(P1, P2 and P3).
t To stop the scan, push [SET
• During full scan
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/ MHz
( )
LOCK
Push to select full,
SET
band* (A1, AA) or programmed
scan (P1, P2 and P3) in se-
quence. (*Depends on versions)
A1 : FM band (136–174 MHz)
AA : AM band (118–136 MHz)
OPT ] for bank scan.
LOCK ] or [V/MHz SCAN ].
• During programmed scan
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/ MHz
Indicates scan edge channels.
• P1 stands for 1A/1b
• P1 to P3 are available when
they are programmed, and
( )
LOCK
switches with .
SET
z Push [VFO/LOCK] to select VFO mode for
SCAN
full/programmed scan; push [MR/CALL] to se-
2
lect memory mode for memory scan.
• Push [BANK/OPTION] to select a bank for bank
SET
scan.
B
x Set the squelch to the point where noise is just
muted.
c Push [
2(T-SCAN)] to start the scan.
SCAN
• Push [Y Y ] or [Z Z ] for 1 sec. also starts the scan.
v Push [
B(D-OFF)] to switch full and pro-
SET
grammed scan (P1, P2 and P3).
b To stop the scan push [
[ A(MW)].
CLR
• During memory scan
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/ MHz
When AM and FM frequencies are programmed into memory
channel disorderly, memory scan takes a lot of time (very slow).
Because changing mode takes a time.
In this case, assign AM and FM frequencies into the separate
bank respectively. And using the bank scan is helpful.
SCAN OPERATION
2(T-SCAN)] or
SCAN
• During Bank scan
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/ MHz
7
7
38