Call Channel Operation; I Calling Up A Call Channel; I Transferring Call Channel Contents - Icom IC-207H Instruction Manual

I Calling up a call channel

Each band has an independent call channel to store a most-
often-used frequency for quick recall.
➀
Push [BAND] one or more times to select a band, if nec-
essary.
➁
Push [M/CALL] once or twice to display a large "C" in the
memory channel readout.
• While a call channel is displayed, pushing [BAND] toggles be-
tween the 2 call channels.
9
H I 5
1
Large "C" shows a call
channel is selected.
➂
Push [V/MHz] or [M/CALL] to exit the call channel.
Ä
Push [BAND] to select the desired band, if nec-
CALL
essary.
Å
Push [ CALL] for 1 sec. to select the call
(MR)
channel.
Ç
Push [BAND] to toggle between the 2 call
channels.

CALL CHANNEL OPERATION

9
H I 5
1
Small "c" shows VFO mode
was selected from a call
channel.
I Transferring call channel
contents
➀
Push [BAND] to select a band, if necessary.
➁
Select the call channel by pushing [M/CALL] once or twice.
• "C1" or "C2" appears—push [BAND] to toggle between them.
➂
Push [S.MW] momentarily, then rotate the tuning dial to se-
lect another memory channel to transfer.
• To transfer to the VFO, push and hold [
pushing momentarily.
➃
Push and hold [ MW] to transfer when a momentary
(S.MW)
push was used in the previous step.
Ä
Push [BAND] to select the desired band, if nec-
MW
essary.
A
Å
Push [ CALL] for 1 sec. to select a call
(MR)
channel, then push [BAND] to select the other
call channel, if desired.
Ç
Push [FUNC], then [EMW] momentarily.
• To transfer to the VFO, push [FUNC] then [EMW] in-
stead of pushing [EMW] momentarily.
É
Push [FUNC] then [EMW] for 1 sec. to transfer
when momentarily pushing [EMW] in step Ç.
7
MW] instead of
(S.MW)
34