Call Channel Operation; Calling Up The Call Channel; Transferring Call Channel Contents - Icom IC-2100H Instruction Manual

7

CALL CHANNEL OPERATION

Calling up the call channel

Use the call channel to store a most-often-used frequency for
quick recall.
Push [M/CALL] one or twice to display a large "C" in the
memory channel readout.
Push [V/MHz] or [M/CALL] to exit the call channel.
Large "C" shows the call
channel is selected.
Push [
(MR)
CALL
nel.
32
5 9
1
Small "c" shows VFO mode was
selected from the call channel.
CALL] for 1 sec. to select the call chan-
Transferring call channel
contents
Select the call channel by pushing [M/CALL] one or twice.
• A large "C" appears.
Push [S.MW] momentarily, then rotate the tuning dial to se-
lect a memory channel to transfer the contents to.
• To transfer to the VFO, push and hold [
pushing momentarily.
5 9
1
Push and hold [
push was used in the previous step.
• If a name (p. 31) has been programmed into the call channel, the
name is also transferred.
Ä Push [
MW
channel.
A
Å Push [FUNC], then [EMW] momentarily.
• To transfer to the VFO, push [FUNC] then push and
hold [EMW] for 1 sec. instead of pushing [EMW]
momentarily.
Ç Push [FUNC] then [EMW] for 1 sec. to transfer
when momentarily pushing [EMW] in step
• If a name (p. 31) has been programmed into the call
channel, the name is also transferred.
MW] instead of
(S.MW)
MW] to transfer when a momentary
(S.MW)
CALL] for 1 sec. to select the call
(MR)
Å .