Call Channel Operation; I Call Channel Selection; I Call Channel Transferring - Icom IC-2200H Instruction Manual

6

CALL CHANNEL OPERATION

I Call channel selection

DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE
➥ Push [MR/CALL] for 1 sec. to select the call
MR/CALL channel.
• Push [
[VFO/LOCK] to select VFO mode.
✔INFORMATION
Small "c" shows VFO was
selected from the call channel.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE
35
➥ Push [M/CALL
PRIO
or twice to select the call
channel.
• "C" appears instead of mem-
ory channel number indication.
Appears
• Push [M/CALL PRIO
turn to memory mode, or push
[V/MHz SCAN ] to select VFO
mode.
PRIO SCAN
M/CALL V/ MHz
] to select memory mode, or push
MR/CALL
When the VFO mode is se-
lected from the call channel,
a small "c" appears instead
of memory channel number.
PRIO SCAN
M/CALL V/ MHz

I Call channel transferring

q Push [M/CALL
] once
channel.
• "C" appears.
w Push [S.MW
lect the memory channel to transfer the contents to.
] to re-
• "M" indicator and memory channel number blink.
• To transfer to the VFO, push [S.MW
e Push [S.MW
tary push was used in the previous step.
• If channel names have been programmed into the call channel,
the names are also transferred.
z Push [MR/CALL] for 1 sec. to select the call
MR/CALL
x Push [FUNC], [
MW
[Y]/[Z]
c Push [FUNC], then [
PRIO ] several times to select the call
MW ] momentarily, then rotate [DIAL] to se-
MW ] for 1 sec.
MW ] for 1 sec. to transfer when a momen-
channel.
A(MW)] momentarily,
CLR
then push [Y Y ]/[Z Z ] to select the memory
channel to transfer the contents to.
• To transfer to the VFO, push [FUNC], then push
[ A(MW)] for 1 sec.
CLR
A(MW)] for 1 sec. to
CLR
transfer when a momentary push was used in
the previous step.
• If channel names have been programmed into the
call channel, the names are also transferred.