Honda Civic Service Manual page 1786

Troubleshooting
!
DTC 1-4
CAUTION: Whenever ths ignition 3wiich is ON {lll, or
has boen turned OFF tor loss than three minutes, bs
caroful not to bump the SRS unit; the airbagls) could
accidoDtally deploy and cause damage or iniulies.
07SAZ - TB,()11A
(2 0 JACKI
CABLE
REEL
2P CONNECTOR
07TAZ - Szsol'lA
24-46
DRIVER'S AIRBAG
CABLE REEL
2P CONNECTOR
Try to roproduc. the SRS indic.lor lightr
1. Erase the DTC memory (see page 24-15).
2. Turn the ignition switch ON (ll), and check that the SRS indi-
cator light comes on tor about six seconds and goes off.
Ooes th6 SRS indicltor liqht stey on?
YES
NO
Intermitid{ failure, 3y3tem b OK at this time. S€e Troublo-
shooting Intormittont Failurss on pago 24.15.
Check for a 3hort to powo. in the d.iver's .irbag inflator:
1. Turn the ignition switch OFF.
2. Disconnect the baftery negative cable, then disconnect
the positive cable, and wait for three minut6s.
3. Disconnect the driver's airbag 2P connector from the
cable reel 2P connector.
CAUTION: Do not disconnoct the parsengcr'r airbag
connactoa.
4. Connect the SRS service connector (2 O) to the cable reel
2P connector.
5. Reconnect the battery positive cable, then reconnect the
negative cable.
6. Erasethe DTC memory (see page 24-15).
7. Read th6 DTC {seo page 24-13},
ls OTC 1-4 indic.tedT
YES
NO
Short to pow.r in the driver'i rirbrg inilrtor; r€pl.co
the driver'! airbag l!e. paga 24-67).
Check for a ahort to Dow€r in tha crblo.eet:
1. Disconnect the battery negative cabl€, then disconnect
the positive cable, and wait for three mrnur€s.
2. Disconnect the special tool (2 O) trom the cable reel 2P
cononector.
3. Bemove the dashboard lower cover, and disconnect the
cable reel 2P connector trom th€ SRS main harness.
4. Connect the special tool 12 0) to the SRS main harness
2P connector.
(cont'd)
fo page 24-47
SRS MAIN HABNESS
t2 0 JACK)