Honda Civic Service Manual page 1720

Cruise Control
t
D
=
t
Astuator Replacement
1 . Pull back the boot, and loosen the locknut. Then dis-
connect the cable from the bracket.
Disconnect the cable end from the actuator rod.
Disconnect the 4P connector from the actuator.
Disconnect the vacuum hosa from the vacuum tank.
Pull out the vent hose.
Remove the three mounting bolts and the actuator
with the bracket.
CABTI
aP CONNECTOR
lf necessary, disconnect the cable end from the link-
age over the accelerator pedal, then turn the grom-
met 90' in the bulkhead, and remove the cable,
Install in the revers€ order of removal, and adjust
free play at the actuator rod after connecting the
cable (see ne)d column).
7 .
VACUUM HOSE
23-244
1 .
Actuator Cable Adjustment
Check that the actuator cable operates smoothly
with no binding or sticking.
Stan the engine. Hold the engine at 3,000 rpm with
no load (Afl'in N or E,
M/T in neutral) untit the
radiator fan comes on, then let it idle.
Measure the amount of movement of the actuato.
rod until the cable pulls on the accelerator lever
(engine speed starts to increase). Free Dlay should
be 11 t 1.0 mm (0.43 I 0.04 in).
LOCKNUT FREE PLAY: 11 1 1.0 mm
{o.i|:l r 0.oit in}
lf free play is not within specs, loosen the locknut,
and turn the adjusting nut as required.
NOTE: lf necessary. check the throttle cable free
play (see section 11). then recheck the actuator rod
free play.
Retighten the locknut, and recheck the free play.
ACTUATOR ROD