Honda Civic Service Manual page 1782

Troubleshooting
DTC 1-1 and DTG 1-2
CAUTION: Whenever the ignition switch is ON 0l), or
has been turned OFF for le33 than three minutes, be
careful not to bump the SRS unit; the airbagls) could
accidentally deploy and cause damage or inluries.
REEL
2P CONNECTOR
AZ - SZ5011A
07sAz-TB{0t1A
t2 0 JACKT
-
CABLE
REEL
2P CONNECTOR
07TAz - SZ5011A
DRIVER'S AIRBAG
SRS MAIN HARNESS
Try to reproduc€ the SRS indicator light:
1. Erase the DTC memory lsee page 24,'15).
2. Turn the ignition switch ON {ll), and check that the SRS indi-
cator light comes on lor about six seconds and goes off.
Does the SRS indicator liqht 3tav on?
Intermittent lailure. system is OK at this time. So€ Tlouble
Intermittent Failur6 on Deqe 24-15.
Check for en open in th€ driver's airbag inllator:
1. Turn the ignition switch OFF.
2. Disconnect the battery negative cable, then disconnect the
positive cable, and wait for three minutes.
3. Disconnect the driver's airbag 2P connector from the cable
reel 2P connector.
CAUTION: Do not disconnect the pa9,!eng6.,s ailbag con-
nector.
4. Connect the special tool {2 0)to the cable reel 2P connec,
tor.
5. Reconnect the battery positive cable, then reconnect the
negative cable,
6. Erase the DTC memory {see page 24 15}.
7. Read the DTC {see paqe 24-13).
ls OTC 1-1 or DTC 1-2 indicatod?
Open or incroas€d resistanc€ in the driver's ai.bag inoa-
tor; r€place the d ve/s airbag lse6 pege 24€?).
Check for an opgn in the cabl6 reel:
1. Disconnect the battery negative cable, then disconnect
the positive cable, and wait for three minutes.
2. Disconnect the special tool {2 O) from the cable reel 2p
connector,
3. Remove the dashboard lower cover, and disconnect the
cable reel 2P connector from the SRS main harness.
4. Connect the special tool {2 0} to the SRS main harness
2P connector,
{cont,
To page 24-43
(2 0 JACK)
24-42
l !