Honda Civic Service Manual page 1778

Troubleshooting
The SRS Indicator Light Doesn't Go Off -'98
- 00 Models (cont'dl
From page 24 36
( D )
Check the SRS indicetor circuit input voltage:
1. Reconnect the SRS main harness l8P connector to the
SRS unit.
2. Connect a voltmeter between the No. 1 terminal (+) of
the dashboard 5P connector and ground.
3 . T u r n t h e i g n i t i o n s w i t c h O N ( l l ) , w a i t f o r s i x s e c o n d s ,
then measure voltage,
ls th€re 8.5 V or more?
YES
NO
The problem has disapp€ared due to di3connecting and
conneding the connectors. Be su.e all te.minals make
good contact, and recheck the system {see T.ouble-
shooting Inte.miftent Failures on page 24-15).
Poor contact et the SRS main harnass 18p connactori check
the connector,
. ll the connector is OK, substitute a known-good SRS unit,
and recheck.
' It the problem is still present, replace the SRS main haF
ness.
From page 24-36
Check for an open in the dashboard wir6 harness:
1. Disconnect the main wire harness 24P connector from
the dashboard wire harness.
2. Check resistance between the No. 6 terminal of the SRS
main harness 18P connector and No. 5 terminal of the main
wire harness 24P connector; there should be 0 - 1.0 0.
ls the resistance as 3pecitied?
YES
NO
Open in the BLU wire ot the dashboard wire harness;
repair the dashboard wire harness.
Check tor an open in the main wire haanoss:
1. Disconnect the SRS main harness 3P connector from the
main wire harness.
2. Check resistance between the No. 6 termanal of the SRS
main harness 18P connector and No. 1 terminal of the SRS
main harness 3P connector; there sho!ld be O - l.O 0.
ls the resistance a! specified?
YES
NO
Open in the BLU wire of the m.in wire ha.ness: .eoair
the main wire harness.
Open in the SFS main hrrness; replace the SRS main har-
ness.
DASHBOARD WIRE HARNESS
5P CONNECTOR
c508
Terminal side of male lerminals
SRS MAIN HARNESS
18P CONNECTOR
c807
c41 l
SRS MAIN HARNESS
18P CONNECTOR
cao2
SRS MAIN HARNESS
3P CONNECTOR
24-38
\
DASHBOARD WIRE HARNESS