Honda Civic Service Manual page 1739

)
Transmitter Programming ('96 - 98 models)
Storing Transmitter Codes
. The codes of up to four transmitters can be stored in the control unit. {lf a {ifth code is stored, the code which was
stored tirst will be erased.)
. When the system enters the registration mode, all previously slored codes will be erased.
. The system leaves the registration mode and returns to the normal mode if you
- turn the valet swirch OFF, or
- t u r n t h e i g n i t i o n s w i t c h O F F , o r
- do not press the transmitter button for more than 10 seconds
Procedure:
NOTE: lt is important to maintain the time limits between steps
VALET SWITCH
NOTE: lf the tuner is turned ON, it will
go off and come on again when the reg-
istration procedure is completed-
l - l
N O T E : l f y o u w a n t t o r e g i s t e r t h e c o d e s
of more than one transmitter, repeat step
4 w i t h i n 1 0 s e c o n d s w i t h t h e n e x t t r a n s '
mitter.
NOTE: After storing its code, make sure
t h e t r a n s m i t t e r w o r k s p r o p e r l y b Y
repeatedly pressing one ot its buttons.
(The system starts to work when You
press any transmitter button six times-)
TRANSMTITTER
23-267
Insert the ignition key into the
ignition swatch.
T u r n t h e i g n i t ; o n s w i t c h O N
flr).
Within 10 seconds, go to steP 3.
3. Press and hold the valet switch
for at least tive seconds.
( Y o u w i l l h e a r t h e s o u n d o f t h e
a c t u a t o r s t u r n a n g t o U N L O C K . )
Within 10 seconds. go to step 4.
4. Press one of the transmitter
buttons,
(You will hear the sound of the
actuators turning to UNLOCK.i
AUDIO UNIT