Honda Civic Service Manual page 1816

SRS Unit
Replacement
CAUTION:
. Betore disconnoqting lny pErt of the SRS wire hal-
ness, disconnect th9 airbag conn"ctorlsl.
. During installltion or teplacemsnt. do not bump
(impact w.cnch, hamm€r stc.l the area noar tho SRS
unit.
NOTE:
o Do not damage the SRS unit terminals or connectors.
. Do not disassemble the SRS unit; it has no service-
able parts,
. Store the SRS unit in a clean, dry a.ea,
. Do not use any SRS unit which has be€n subjected to
water or shows signs of being dropped or improperly
handled. such 8s dents, cracks or deformation.
1. Disconnect the bsttery negative cable. then discon-
nect the positive cable from the battery, and wait at
least three minutes.
2. Disconnect the airbag connector{s}:
NOTE: When disconnected, the airbag connector is
automatically shorted,
Driver's Side:
. Remove the access panel from the steering wheel.
then disconnect the 2P connector between the driv_
er's airbag and cable reel (see page 24-11).
Front Passenge/s Side:
. Disconnect the 2P connector between the tront oas_
senger's airbag and SRS main harness (see page 24-
1 1 ) .
24-76
o \
3. Remove the right side cover from the SRS unit.
SRS UNTT
TOBX
BOLTS
Uge a Torx
T30 bit.
RIGHT SIOE
Remove the left side cover from the SRS unit, then
d i s c o n n e c t t h e S R S m a i n h a r n e s s l g p c o n n e c t o r
from the SBS unit.
SRS UNIT
5. Remove the four Torx bolts from the SRS unit, then
pull out the SRS unit from the driver,s side,
COVER