Configuring an EtherChannel Using PAgP
This example shows how to display traffic utilization on EtherChannel ports:
Console> (enable) show channel traffic
ChanId Port
------ ----- ------- ------- ------- ------- ------- -------
Console> (enable)
Displaying the Outgoing Ports for a Specified Address or Layer 4 Port Number
To display the outgoing port that is used in an EtherChannel for a specific address or Layer 4 port
number, perform this task:
Task
Display the outgoing port for a specified
address or Layer 4 port number.
This example shows how to display the outgoing port for the specified source and destination IP
addresses:
Console> (enable) show channel hash 808 172.20.32.10 172.20.32.66
Selected channel port:2/17
Console> (enable)
Disabling an EtherChannel
To disable an EtherChannel, perform this task in privileged mode:
Task
Disable an EtherChannel.
This example shows how to disable an EtherChannel:
Console> (enable) set port channel 2/2-8 mode off
Ports 2/2-8 channel mode set to off.
Console> (enable)
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
6-12
Rx-Ucst Tx-Ucst Rx-Mcst Tx-Mcst Rx-Bcst Tx-Bcst
808
2/16
0.00%
0.00%
808
2/17
0.00%
0.00%
816
2/31
0.00%
0.00%
816
2/32
0.00%
0.00%
50.00%
75.75%
0.00%
50.00%
25.25%
0.00%
25.25%
50.50%
0.00%
75.75%
50.50%
0.00%
Command
show channel hash channel_id src_ip_addr vlan
src_port [dest_ip_addr vlan dest_port]
show channel hash channel_id dest_ip_addr vlan
dest_port
Command
set port channel mod/port mode off
Chapter 6
Configuring EtherChannel
0.00%
0.00%
0.00%
0.00%
OL-8978-04