Configuring The Ethernet Management Port - Cisco Catalyst 4500 Series Configuration Manual

Defining and Using Interface-Range Macros
•
•
•
•
•
•
•
•
•
Caution Before enabling a feature on the Ethernet management port, ensure that the feature is supported. If you
try to configure an unsupported feature on an Ethernet management port, the feature might not work
properly, and the switch might fail.

Configuring the Ethernet Management Port

To specify the Ethernet management port, enter fastethernet1.
To disable the port, use the shutdown interface configuration command. To enable the port, use the
no shutdown interface configuration command.
To determine the link status to the PC, you can monitor the LED for the Ethernet management port:
•
•
•
To display the link status, use the show interfaces fastethernet 1 privileged EXEC command.
Defining and Using Interface-Range Macros
You can define an interface-range macro to automatically select a range of interfaces for configuration.
Before using the macro keyword in the interface-range macro command string, you must define the
macro.
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
7-10
Secure Shell (SSH)
DHCP-based autoconfiguration
SNMP (only the ENTITY-MIB and the IF-MIB)
IP ping
Interface features
Speed—10 Mb/s, 100 Mb/s, 1000Mb/s, and autonegotiation
–
Duplex mode—Full, half, and autonegotiation
–
– Loopback detection
Cisco Discovery Protocol (CDP) (only on WS-C4900M and WS-C4948)
IPv4 access control lists (ACLs)
Routing protocols (only on WS-C4900M and WS-C4948)
AAA
The LED is green (on) when the link is active.
The LED is off when the link is down.
The LED is amber when there is a POST failure.
Chapter 7 Configuring Interfaces
OL-25340-01