Changing The Channel Mode; Specifying The Channel Path Cost; Specifying The Channel Vlan Cost; Configuring Channel Load Balancing - Cisco WS-C6506 Software Manual

Catalyst 6500 series switch
Hide thumbs Also See for WS-C6506:
Table of Contents

Advertisement

Configuring an EtherChannel Using LACP

Changing the Channel Mode

You can change the channel mode for a set of ports that were previously assigned the same administrative
key (see the
To change the channel mode, perform this task in privileged mode:
Task
Change the channel mode.
This example shows how to change the channel mode for ports 4/1 and 4/6, setting it to on. The
administrative key for ports 4/1 and 4/6 is unchanged.
Console> (enable) set port lacp-channel 4/1,4/6 mode on
Port(s) 4/1,4/6 channel mode set to on.
Console> (enable)
Use the show lacp-channel group admin_key command to display the channel mode for ports.

Specifying the Channel Path Cost

You can specify the channel path cost by using a global command that configures both LACP and PAgP.
For more information, see the

Specifying the Channel VLAN Cost

You can specify the channel VLAN cost by using a global command that configures both LACP and
PAgP. For more information, see the

Configuring Channel Load Balancing

You can configure channel load balancing by using a global command that configures both LACP and
PAgP. For more information, see the

Clearing the LACP Statistics

To clear the LACP statistics, perform this task in privileged mode:
Task
Clear LACP statistics.
This example shows how to clear LACP statistics:
Console> (enable) clear lacp-channel statistics
LACP channel counters are cleared.
Console> (enable)
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
6-18
"Specifying an Administrative Key Value" section on page
"Setting the EtherChannel Port Path Cost" section on page
"Setting the EtherChannel VLAN Cost" section on page
"Configuring EtherChannel Load Balancing" section on page
Command
set port lacp-channel mod/ports mode [on | off |
active | passive]
Command
clear lacp-channel statistics
Chapter 6
Configuring EtherChannel
6-16).
6-9.
6-9.
OL-8978-04
6-11.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 6506Catalyst 6509Catalyst 6513

Table of Contents