Chapter 6
Configuring EtherChannel
Configuring an EtherChannel Using LACP
These sections describe how to configure EtherChannel using LACP:
•
•
•
•
•
•
•
•
•
•
•
•
•
Before you configure the EtherChannel, see the
Note
page
Specifying the EtherChannel Protocol
The default protocol is PAgP.
Note
You can specify only one protocol, PAgP or LACP, per module.
Note
To specify the EtherChannel protocol, perform this task in privileged mode:
Task
Specify the EtherChannel protocol.
This example shows how to specify the LACP protocol for modules 2 and 3:
Console> (enable) set channelprotocol lacp 2,3
Mod 2 is set to LACP protocol.
Mod 3 is set to LACP protocol.
Console> (enable)
Use the show channelprotocol command to display the protocols for all modules.
OL-8978-04
Specifying the EtherChannel Protocol, page 6-15
Specifying the System Priority, page 6-16
Specifying the Port Priority, page 6-16
Specifying an Administrative Key Value, page 6-16
Changing the Channel Mode, page 6-18
Specifying the Channel Path Cost, page 6-18
Specifying the Channel VLAN Cost, page 6-18
Configuring Channel Load Balancing, page 6-18
Clearing the LACP Statistics, page 6-18
Displaying EtherChannel Traffic Utilization, page 6-19
Displaying the Outgoing Ports for a Specified Address or Layer 4 Port Number, page 6-19
Disabling an EtherChannel, page 6-19
Displaying the Spanning-Tree Information for EtherChannels, page 6-20
6-3.
"EtherChannel Configuration Guidelines" section on
Command
set channelprotocol [pagp | lacp] mod
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring an EtherChannel Using LACP
6-15